55
English
• Set the control to the OFF position and lock it using a hairpin
clip.
• Refit the cover in the guides of the safety guard.
Adjusting the height of the belt conveyor
You can set the belt conveyor to an angle thus allowing you to change the loading height.
For this, you must move the transverse beam (1) on which the belt conveyor rests at the rear of
the machine.
Several attachment holes (2) are provided.
First detach the belt conveyor from the machine before unscrewing this transverse beam.
Loosen the M8 bolts on either side (SW13). Move the transverse beam to another attachment
hole and then refit the bolts.
Tighten the bolts so that the belt conveyor remains secure when it is operating.
Hook the belt conveyor back onto the machine and check that the loading height is adequate.
Checking the belt conveyor for correct belt tracking
In the event of inaccurate belt tracking, it must be aligned for true running.
• Always check the belt conveyor for correct tracking when fitted to the machine.
• Start the engine and switch on the belt conveyor. Allow the machine to run for two minutes
until the shredding chamber is completely empty.
Summary of Contents for MA 006 010 113
Page 1: ...Superprof M A N U A L...
Page 2: ...2 English...
