34
s
ervicing instructions
The following outlines only the minimum work that
should be performed on an annual basis. This
service work, like any other work on the appliance,
must only be done by a qualified and competent
engineer who is Gas Safe registered.
Open the door and remove all ceramics.
Remove Grate from the firebox.
Remove any debris from the top of the burner
using a vacuum cleaner and brush.
Inspect the burner unit.
Perform an ignition check.
Perform a flame failure check
There should be no need to service the burner. If
however this is required, then the engineer should
check the setting pressure at inlet to burner;
the correct pressure is shown at the rear of the
manual.
Brush off and replace ceramic arrangement as
earlier in this manual, replacing any broken or
damaged pieces.
Check all seal on door (including glass) and re-
place the Door.
Check the installation for gas leaks.
Check flue for clearance of products of combus-
tion.
If any parts need to be replaced use only genu-
ine manufacturer parts, non-standard parts will
invalidate the guarantee and may be dangerous.
Troubleshooting
On the next pages you will find remedies for
problems which may accur when using fires
with full electronic ignition RCE GV60
Figures troubleshooting
SERVICING INFORMATION
34
servicing instructions
The following outlines only the minimum work
that should be performed on an annual basis.
This service work, like any other work on the
appliance, must only be done by a qualified and
competent engineer who is Gas Safe registered.
Open the door and remove all ceramics.
Remove Grate from the firebox.
Remove any debris from the top of the burner
using a vacuum cleaner and brush.
Inspect the burner unit.
Perform an ignition check.
Perform a flame failure check
There should be no need to service the burner.
If however this is required, then the engineer
should check the setting pressure at inlet to
burner; the correct pressure is shown at the rear
of the manual.
Brush off and replace ceramic arrangement as
earlier in this manual, replacing any broken or
damaged pieces.
Check all seal on door (including glass) and
replace the Door.
Check the installation for gas leaks.
Check flue for clearance of products of combus
-
tion.
If any parts need to be replaced use only genu-
ine manufacturer parts, non-standard parts will
invalidate the guarantee and may be dangerous.
Troubleshooting
On the next pages you will find remedies for
problems which may accur when using fires
with full electronic ignition RCE GV60
Figures troubleshooting
Figure 1
Figure 2
SERVICING INFORMATION
A
Summary of Contents for Bidore 140
