Page 19 of 40 M8144
Issue 2.0
7.5.18. The IA now says Display. This alows both settings and melt data to be viewed on the
display. Press 1 for yes or 2 for no. If 1 = yes is selected you will see the following
information. Press the return key to view the next field.
Date and first melt recorded time.
The set Ramp rate.
M1 melt temperature.
M2 melt temperature (assuming it was recorded).
M3 melt temperature (assuming it was recorded).
M4 melt tempeature (assuming it was recorded).
To exit view
melt data without viewing all the stored data press the ‘Fn’ to sequence
into the printing option.
To exit viewing the melt data and return to F2 screen inorder to view another stored
batch press
the ‘C’ key.
7.5.19. You are now asked if you wish to print out the recorded data. Press 1 for yes or 2 for
no. Ensure a printer is connected before selecting 1 for a print.
7.5.20. You are now asked if you which to output the data via a USB Pendrive. Press 1 for
yes or 2 for no. If you press 1 for yes you are asked to insert a USB flash drive. Your
data will be uploaded to the flash drive. It can be read on your PC using ‘Notepad’.
7.5.21. You are asked if you want to send the melt data direct to your PC. Press 1 for yes or
2 for no. Ensure your IA is connected to your PC using the slave socket.
7.5.22. You are asked if you wish to delete stored data. Press 1 for yes or 2 for no. You are
now returned to the F1 home screen.
F3 Setup Mode.
7.5.23.
From the F1 home screen press the ‘Fn’ key twice to enter F3 setup mode screen.
Press the return key to accept access.
7.5.24. Time and date settings and adjustments are made here. See section 7.4.
ECO Mode settings 9200
7.5.25. From the F1 home scr
een press the ‘Fn’ key twice to enter F3. Setup mode. Press
‘Enter’ key to select setup mode. You may now change the time and date (see 7.3) or
Press the
‘Fn’ key again to enter ECO mode settings.
. To decline
press the function key where you are taken back to the F1 home screen.
