Electronics Line Commpact, Installation Manual

Page: 99 / 160

Appendix B: Transmitter Installation
CommPact Installation Manual
95
LED Indication
The LED indicator turns red to indicate non ‐ permitted motion and green to indicate motion
detection in either direction. In the event of an alarm, the LED turns red. To disable the LED,
remove the LED Jumper, JP1 located next to the LED indicator – see Table B ‐ 5.
Do not disable the LED until you have successfully walk tested the detector.
PIR Supervision
The circuit operation of the PIR is checked once per hour. In the event of PIR failure the red
LED flashes.
Battery Replacement
Open the housing by removing the front cover (see Installation Instructions), replace the battery, and
close the front cover.
Close the front cover immediately after each battery replacement.
Table B-3: EL-2650XL's
Mode JumperJP3 Table B-4: EL-2650XL's Alarm
Delay Jumper JP Table B- 5: EL-2650XL's LEDs
Mode
Jumper
JP3 Jumper
Position
Alarm Delay
Jumper JP2
Jumper
Position LED Indication
Curtain Removed 1 minute Removed Red Non-Permitted
motion
Directional Installed 4 minutes Installed Green Permitted Motion
Signals and Messages:
In case of a low battery (2.5 V and below), the detector low battery condition is reported to the
Control System and low battery message is displayed. When the Back Tamper switch is released,
the detector sends a tamper condition to the Control System that generates tamper alarm.
Wall Mounted Ceiling mounted
Figure B- 10: Lens Coverage Pattern (Side View)