Electrolux EWFLW65H - 27'' Front-Load Washer, Technical & Service Manual

Page: 65 / 92

4-3
Component Teardown
This section will describe how to remove servicea-
ble components from the washer. Unless stated,
the procedure will be the same on all models.
Unless stated, reverse the procedure to reinstall the
component.
Door Components
Door Trim Ring Removal
The door is secured to a hinge assembly mounted
to the unit frame. The trim ring must be removed to
access and remove the hinge assembly.
To remove the door assembly:
1. Open the door to a 90 degree angle.
2. Using a #2 square bit screwdriver, extract
and save the trim plug and long course thread,
panhead screw. (See Figure 4-1)
3. Close the door.
4. Rotate the door trim approximately ¾”
counter-clockwise and pull it away from the
front of the door. (See Figure 4-2)
Door Assembly Removal
The door assembly is secured with 4 screws to the
hinge assembly. It is not necessary to remove the
trim ring to access the hinge screws of the door
assembly.
To remove the door assembly:
1. Open the door to a 90 degree angle.
2. Using a #2 square bit screwdriver, extract
the 4 long, course thread, countersunk
hinge screws from door. (See Figure 4-3)
3. While supporting the weight of the door with
both hands, separate the door from the hinge.
(See Figure 4-4)
4. Gently place the door face down on a flat,
covered work surface.
Figure 4-1.
Figure 4-2.
Figure 4-3.
Figure 4-4.
Trim Plug
Trim Ring
Door Hinge Screws