Electrolux EWFLW65H - 27'' Front-Load Washer, Technical & Service Manual

Page: 55 / 92

Electronic Control
3-17
System Clean
To clean and freshen the washer, perform the
SYSTEM CLEAN cycle. If you wish to begin the
cycle, press select when prompted. The next
screen will instruct you to remove all items from the
wash drum, fill the bleach dispenser and press
start. This maintenance cycle uses hot water and
two rinses to remove residue that may cause odor.
The washer will automatically prompt you to run
the SYSTEM CLEAN cycle every 50 cycles. You
may press the button under EXIT to manually
perform the cycle at another time.
Reset (WaveTouch™)
Press the buttons indicated to restore only cycle
settings, reset only factory preferences (users,
language, brightness, volume, etc.) or restore
all factory defaults (both cycle settings and factory
preferences). Press the button under EXIT
to return to normal operation or press the cancel
button to turn the washer off without making any
changes. If you do not make a selection within
30 seconds the washer will return to normal
operation without any changes. If you reset all
settings, “
INSTALL CYCLE” will be displayed as
though the washer were just turned on for the first
time. Press the button under CANCEL if you do
not wish to rerun the INSTALL CYCLE.
Reset (IQTouch™)
For IQTouch™ models, wake machine, push the
spin speed and soil selection keys simultaneously
and hold until you hear a beep.
Contrast
Press the button beneath plus (+) or minus (-)
symbols to increase or decrease the contrast of
the display. Press select to accept the change or
press the button under EXIT to return to normal
operation without any changes.