Electrolux EWFLW65H - 27'' Front-Load Washer, Technical & Service Manual

Page: 84 / 92

4-22
Component Teardown
Tub Assembly Removal (continued)
14. The seal between the (2) tub halves is placed
in the groove of the rear half and can be lifted
out with a flat bladed screwdriver.
(See Figure 4-60)
15. To remove the spin basket, set the back half of
the outer tub on its side, reinstall the screw
that holds the large pulley on and tap the inner
tub out with a rubber hammer.
(See Figure 4-61)
NOTE: The bearings, water seal and seal between
the two tubs come as part of the rear half of the
outer tub. If the water seal or bearings fail, inspect
and if necessary dress the shaft of the spin basket
with a file. With some failures, it may be
necessary to replace the spin basket.
Figure 4-60.
Figure 4-61.
Screwdriver
Seal
Pulley Screw
Bearing