SOI/ADL 2009-10
8/63
599 72 40-73
2.1.5 Example of display of alarm code
In the event of, for example, alarm E53 (problems with the motor triac), the code will be displayed as follows:
the sequence of
five
flashes of the ANTI-CREASE/END OF CYCLE LED indicates the first of the two
numbers in the alarm code E"
5
"3, which represents the family and is displayed to the user.
the sequence of
three
flashes of the START/PAUSE LED indicates the second number E5"
3
".
Time (sec)
0.4
0.4
0.4
0.4
0.4
0.4
0.4
0.4
0.4
0.4
2.5
End of cycle
LED
Value
1
2
3
4
5
Pause
Pause LED
Value
1
2
3
Pause
2.1.6 Rapid reading of the alarm codes
The last alarm code memorized can be displayed even if the appliance is in normal operating mode (e.g.
while the drying programme is being performed):
Press
START/PAUSE
and
any one of the option buttons
simultaneously for at least two seconds. The
LEDs switch off, then display the flashing sequence that identifies the alarm code.
The alarm sequence continues to flash as long as the two buttons are held down.
The reading system is as described in paragraph 10.2.1.
The appliance continues the cycle while the alarm codes are being displayed. If the appliance is in
programme selection mode, the options previously selected are stored in memory.
2.1.7 Cancelling the last alarm memorized
It is good practise to cancel the alarm code from memory:
•
After reading the alarm, to check whether it is repeated during the diagnostics cycle.
•
After effecting repairs to the appliance, to check whether it is repeated during testing.
1. Access diagnostics mode and turn the programme selector knob to the
eleventh
position (alarm
reading).
2. Press
START/PAUSE
and
any one of the option buttons
simultaneously.
3. Hold down the START/PAUSE and option buttons for about 5 seconds.
2.1.8 Notes concerning certain alarm codes
