SOI/ADL 2009-10
12/63
599 72 40-73
The alarm code is displayed by a repeated sequence of flashing of the ANTI-CREASE/END OF CYCLE LED
(0.4 seconds on, 0.4 seconds off, with a pause of 2.5 seconds between sequences).
The buzzer emits a series
of "bips" in synchronization with the flashing of the LED.
ANTI-CREASE/END OF CYCLE LED:
indicates the first number of the alarm code (family)
START/PAUSE LED:
indicates the second number of the alarm code (number within the family
category).
If no alarm conditions occurred
“E00” is displayed.
2.3.4 Reading the alarm codes
The last alarm code memorized can be displayed even if the appliance is in normal operating mode (e.g.
while the drying programme is being performed):
Press
6
(start/pause) and 4 simultaneously for at
least 5 seconds: the display shows the last alarm.
If the display is not featured the displaying is
indicated by the flashing of the END OF CYCLE /
START-PAUSE LEDs.
The alarm sequence continues to flash as long as
the two buttons are held down.
The appliance continues the cycle while the alarm
codes are being displayed. If the appliance is in
programme selection mode, the options previously selected are stored in memory.
2.3.5 Cancelling the last alarm memorized
It is good practise to cancel the alarm code from memory:
•
After reading the alarm, to check whether it is repeated during the diagnostics cycle.
After effecting repairs to the appliance, to check whether it is repeated during testing.
4.
Access diagnostics mode and turn the
programme selector knob to the
eleventh
position (alarm reading)
Turn the knob to the
position 11, paying attention not to stop at position
7, because error 32 may occur 32
.
5.
Press buttons
6
(start/pause) and
4
simultaneously.
6.
Hold down buttons
6
and
4
(about 5
seconds).
7.
Once the alarm has been cancelled,
E00
is
displayed.
2.3.6 Notes concerning certain alarm codes
Configuration alarm E93:
When configuration alarms are displayed (when the
appliance is switched on), the appliance is inoperative and all the LEDs light. It is not
possible to access diagnostics mode; the only possible operation is that of switching
off the appliance (selector knob on position "0").
