26
ATTENTION!
Value fields are separated by commas. Maximum SMS length is 160 characters. Only one input parameter can be configured by
one SMS message.
Examples of using SMSEXTRA command.
Suppose in all cases initial parameters were not changed and are manufacturer default.
1. Example of SMS message configuring Z1 input:
This message configures Z1 input parameters.
SC15 means that during the alarm SMS message sending is disabled for users NO1 and NO5. As per manufacturer default settings
SMS sending is preset for all users, therefore users NO2, NO3 and NO4 SMS messages will still be delivered.
CC25 means that during the alarm calling function is disabled for users NO2 and NO5. As per manufacturer default settings, calling
function is preset for all users, therefore users NO1, NO3 and NO4 will still be called.
SE1234 means that SMS restore message sending is enabled for users NO1, NO2, NO3 and NO4. This means that when input Z1 is
restored after previous violation, these users will be informed about this restore event by SMS message. However, alarms and restore
SMS messages will be sent until the first successful delivery. To enable mandatory message delivery to all users you should use the
command XXXX_SMSALL:ON, as described in chapter 3.7.
CE4 means that during input Z1 restore only user NO4 is called.
LE1 means that input type for input Z1 will be inverted, i. e. the previous NO is changed to NC (normally closed). This means that the
input is violated only when the signal disappears, and the input is restored only in case when the signal appears.
DV900 means that input Z1 is violated only if the signal is suspended at least for 900ms. Please note that input type was inverted to
NC. (If inversion was not possible this DV900 command would mean that the signal transmitted must not be shorter than 900ms.)
2. Example of SMS message configuring Z2 input:
This message configures Z2 input parameters.
IE1 means that impulse counting mode is enabled for Z2 input.
IC555 means that the users will receive the alarm when 555 impulses are transmitted to the input. Immediately after the alarm the
counter resets and starts counting impulses until their number reaches 555.
To see the preset values for any command send SMS message with the same format that you use when changing parameters; only
Value structure will have no value:
XXXX – user password.
Zn – possible values Z1,Z2,Z3,Z4,Z5. Define the number of the input being changed.
Value structure is Cn, where Cn is command name (2 letters).
E. g. XXXX_SMSEXTRA:Z2:SS,SC,CC,SE,SD
XXXX_SMSEXTRA:Z1:SC15,CC25,SE1234,CE4,LE1,DV900
XXXX_SMSEXTRA:Z2:IE1,IC555
XXXX_SMSEXTRA:Zn:Value1,Value2,……,ValueN
ESIM 252
XXXX_
SMSEXTRA:
Z2:SS,SC,
CC,SE,SD
FOR ADVANCED USERS
All these features can be configured using program “ELDES Configuration Tool“
Summary of Contents for ESIM252
Page 1: ...GSM CONTROL SYSTEM ESIM252 ...
Page 33: ...USER MANUAL ELDES ESIM252 V1 0 33 ...
Page 34: ...34 For notes ...
