Eldes ESIM252, User Manual

Page: 12 / 36

12
3.5 Remote Microphone Listening
NOTE
To enable this feature it is necessary to connect microphone connector to MIC slot. The microphone is additional equipment
tha can be purchased in trading centers.
You can listen to what is going on in the secured premises by sending the following SMS message:
The system will ring the sender of the received SMS, and upon answering the call, the user can listen to any sounds in the building.
The phone call must be answered within 20 seconds otherwise the system will stop trying and return to previous state.
3.6 Managing C1 & C2 Outputs. Timer.
GSM control system ESIM252 contains two outputs C1 and C2. It can be used to control various electric appliance, such as electric
pumps, heating, lighting etc. When the output (-s) is turned on, the relay connectors of the output are in NC state (normally closed).().
The output is turned on by sending the following SMS message:
x - output number; possible values 1 - C1 or 2 - C2.
The output is turned off by sending the following SMS message:
x - output number; possible values 1 - C1 or 2 - C2. Instead of C1 or C2 it is also possible to use real output name.
E.g.. XXXX_PUMP:ON
Timer
GSM control system ESIM252 has internal timer. This feature allows any output to be turned on or off for a specified time period.
The following SMS command should be sent:
x - output number; possible values 1 - C1 or 2 - C2. ON – output enabled. OFF – disabled
vv – hours, valid values [00-23] mm – minutes, valid values [00-59] ss - seconds, valid values [00-59]
It is not allowed to have all values equal zeros. Zeros it is not allowed to have all values equal
E. g. to switch the pump on for 01 minutes and 23 seconds, send SMS XXXX_PUMP:ON:00.01.23
If the pump was enabled before and user want to disable it for 01 minute and 23 seconds, send SMS
XXXX_PUMP:OFF:00.01.23
If you want to use more capabilities of the outputs, such as TOGGLE, automatic output control at a
particu lar, use configuration software „ELDES Configuration Tool“ or refer to chapter 3.9.2
3.7 SMS Message Delivery to Multiple Users
Upon activated alarm in security system, ESIM252 SMS messages are repeatedly sent until first successful delivery to one of the
users. The system starts with NR1 and if delivery fails, it follows with NR2 etc.
It is also possible to set the system so that it sends SMS message to all preset users in the system.
XXXX_MIC
XXXX_Cx:ON
XXXX_Cx:OFF
XXXX_Cx:ON/OFF:vv.mm.ss
ESIM 252
XXXX_
PUMP:
ON
ESIM 252
XXXX_
PUMP:
OFF:00.
01.23