© Elcom s.r.o.
Euro-2000M Alpha
Program manual
43
3.10.5. Programming of PLU bar codes
There are
two methods
of PLU bar code programming :
1. Programming by means of keyboard - the numeric digits of the bar code are entered manu-
ally from the cash register keyboard
2. Reading of the bar codes from the package of the goods with the bar code scanner.
The cash register enables both methods of programming (by entering the bar code either of these methods
is understood).
Programming procedure:
Enter the bar code of the goods and press the
V
button. After pressing the
V
button, the cash
register verifies whether the entered bar code is not assigned to any other PLU. If there is a duplicate PLU,
the information will appear on the display.
By pressing the
H
(CLEAR) button the register is returned to programming the PLU code of the item origi-
nally desired.
If the entered code had not been assigned yet to any other PLU, the register continues programming the next
PLU. To exit the programming mode press the
W
button. After pressing it, the register starts to sort the
bar codes signaled on the display. The sorting time depends on the number of programmed bar codes. After
sorting the register returns to the basic programming mode P MODE.
Display:
The PLU No. 1 bar code programming.
Display:
Display information on duplicate code.
Display information on bar code sorting.
00001.PLU BAR CODE
8586001760034
DUPLICATE CODE
8586001760034
Display:
BAR CODE SORTING
PLEASE WAIT
Note 1: If you switch off the register during the sorting, you can continue sorting by switching back the
register on.
Note 2: To secure a reliable functioning of bar code scanning it is important to program the scanner cor-
rectly and connect it properly to the cash register.
Parameters of setting the bar code scanner:
number of data bits
- 8
parity
- none
stop bit
- 1
transmission speed - according to setting of the fifth register system flag
end character
- according to setting of the fifth register system flag
