26
7. Now you need to file away about 2mm of material from the sloping surface of
the small, approximately 5 x 5 mm plastic components. It is better to >>file off a
bit more rather than a bit less<< , otherwise when you have re-assembled the
drawer, you will not have obtained the desired result, and this will mean having
to repeat the whole procedure one more time.
8. The small surfaces on both plastic components need to be filed down. These
surfaces should maintain the existing sloping edge, so that later, when they have
been re-assembled that can >>glide<< more easily behind the housing frame.
After final re-assembly, the drawer, after the appliance has been reinstalled in its
housing, should descend slightly (4-5 mm) and engage.
You will need to file off
about 2 mm of plastic from
the upper corner of this stop
using a small file.
File off about 2 mm from the top corner of the small
(approx. 5 x 5 mm) sloping surface only. In normal use the
draw should engage on this sloped surface. The appliance
should not glide out of its housing when the handle is lifted,
otherwise when the stops are lowered and engaged on the
drawer should slide out.
Summary of Contents for SUPREME DED400XP1
Page 1: ...EXPRESSO DED400XP1 ...
