4
Fri01/09/17 9:00
Welcome
A1 A2 A3 A4
Area 1
Fri01/09/17 9:00
Area 3
3
– Press
OK
while the interface is idle.
The above row shows user’s pertaining areas, below row
shows the currently operating area.
– Press the number key (1, 2, 3 or 4) corresponding to the
desired area (such area can be accessed only if the user
has sectors authorised for the area).
– Press
OK
to confirm,
STOP
to exit.
The LEDs will indicate the status of the area just set (not that
of the presenting area).
The keypad shows presenting area again one minute
after the last button has been pressed.
2.2.2 User menu
A
user menu
is available at keypad.
User menu items allow users to manage basic maintenance.
▼ MAINTENANCE
→ BYPASS ZONES
→ INSTALLER AUTH.
→ OUTPUT CONTROL
→ MANAGE SIM BAL.
→ CLOCK SETUP
→ CLOCK CALIBR.
→ WEEKLY PROGRAMMER
→ MANAGE USERS
→ PHONE NUMBERS
→ CHANGE CODE
→ SYSTEM TEST
→ MANAGE CHIME
→ EVENTS LOG
For more information: paragraph 2.5
p. 9
2.2.3 User code and keypad locked
The most part of commands from keypad requires a 6-digit
user code.
If during installation the option
Enable keypad locking for
error code
has been enabled, the keypad will be blocked
after the wrong code has been entered for three times.
The following message will be displayed for 90 seconds:
TEMPORARY
DISABLEMENT
Further options are available for associating tamper
events generation with wrong codes typing. Please
see product programming manual.
2.3 Display the status
"Status display" menu pages will display information of the
operating area previously selected.
To enter the menu:
Fri01/09/17 9:00
Welcome
ZONES STATUS
(Up Down Ok Stop)
– Press arrow keys ↑ or ↓ while the interface is in idle mode.
If
Visualisation protection
option is enabled (for
EN50131 standard compliance), the user will have to
enter user code and then use arrow keys to go to "sta-
tus display" menu pages.
There are 4 options available:
ZONES STATUS
,
ANOMALIES
STATUS
,
ALM/TAMP MEMORY
,
GSM STATUS
.
– Press
OK
to enter a menu/submenu,
STOP
to exit.
– When in submenu pages, use arrow keys ↑ or ↓ to display
relevant data.
2.3.1 Check zones status
– Go to
ZONES STATUS
.
– Press
OK
to enter the menu item.
– Use arrow keys ↑ or ↓ to browse the reports.
If there are no reports on the page, the following message
will be displayed:
Summary of Contents for PREGIO Series
Page 22: ...22 ...