EINHELL BT-LS 810 D, Operating Instructions Manual

Page: 230 / 276

Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1. Chain stopper
2. Chain stopper setting screw
3. Scale for setting grinding angle
4. Locking screw for grinding angle setting
5. Chain bar for chain
6. Chain locking screw
7. Setting screw for limiting depth
8. Grinding
wheel
9. ON/OFF switch
10. Grinding head
11. Power cord
3. Intended use
The chain sharpener is designed for sharpening saw
chains.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Rated voltage: 230V
~
50Hz
Power input: S2 20 min 85 watts
Idle speed: 4800min
-1
Adjustment angle: 35º to the left and right
Grinding wheel Ø (inside): 23mm
Grinding wheel Ø (outside): max. 108mm
Grinding wheel thickness: 3.2mm
Lpa noise level: 80 dB (A)
Lwa peak noise level: 93 dB (A)
Totally insulated: II /
쏾
Weight: 2.15kg
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Assembly (Fig. 3-6)
앬 Place the chain clamping mechanism in the
chuck (Fig. 3) and screw from underneath using
the star screw (Fig. 4)
앬 Before starting the chain sharpener, fasten it
securely to a suitable surface (e.g. a workbench)
at a suitable place (protected against dust, dry,
well-lit) using M8 fixing screws and washers (Fig.
5)
앬 Make sure when doing so that the mounting
plate of the chain sharpener is pushed onto the
surface as far as it will go (Fig. 6)
6. Operation (Fig. 7-11)
Important! Always switch the appliance off and
unplug the power plug before making any
adjustments.
6.1 Insert the chain that is to be sharpened into
the chain bar (Fig. 7)
앬 To do this, loosen the chain locking screw (1)
10
GB
Anleitung_BG_CS_85_E_SPK1:_ 05.06.2008 14:21 Uhr Seite 10