Eiki LC-XT6, Service Manual

Page: 26 / 286

-26-
Lens Mounting
- 3 -
4
Remove the Cover Plate by lifting upwards.
(See Fig. 4)
5
This projector can use three (3) different types
of Light-Block Plates, use the Light-Block Plate
that corresponds to the appropriate optional
lens. (Refer to the list below.)
NOTE:
L
Make sure the shape of the Light-Block Plate is
correct.
L
Make sure the mark (UP/DOWN and FRONT/BACK)
on Light-Block Plates are correct and set them
properly.
L
Use two (2) Light-Block Plates for AH-32022.
Light-Block Plate for each Lens
Light-Block Plate
Type No. (PART No.)
Lens Part No.
Type FK2A
(T0CRM0013--1)
AH-21202, AH-32022*,
AH-21092, AH-21023
Type FK2B
(T0CRM0014--1)
AH-32401, AH-32601,
AH-21102, AH-22051,
AH-32581
(T0CRS0008--1) AH-32022*
6
Insert the lower Light-Block Plate. (See Fig. 5.)
7
Grasp (release lock) the Lens Lock Lever and
turn it fully upward. (See Fig. 6) Install the
Lens into the projector. Grasp the Lens Lock
Lever and turn the Lever fully downward until
lever is Locked (clicked position) properly. (See
Fig. 7) When installing the Motor Driven
Lens, be sure to mount Lens Motor on right
side. (See Fig. 1)
After installing the lens, make sure the lens is
not loose and properly installed.
Fig. 6
Fig. 7
LENS LOCK RELEASE
LENS LOCK
NOTE:
L
The Light-Block Plate FK2A and FK2B are separated
to the upper and lower plates.
Lower Plate
Upper Plate
DOWN
UP
Cover Plate
Fig. 4
Fig. 5
Grasp (unlock)
Lens Lock Lever
and pull upward.
Grasp (unlock)
Lens Lock Lever
and fully pull
downward until it is
locked (clicked).