EFI Fiery Central Solo, Service Manual

Page: 35 / 72

35 Service Guide: Fiery Central Solo for KM
Service Procedures
2 Angle the motherboard so that the connectors on the motherboard fit into the cutouts in the connector panel of
the chassis, and gently slide the motherboard into the chassis (see Figure 15 on page 34).
3 Align the mounting holes on the motherboard with the screw holes located in the base of the chassis (see Figure 14
on page 32 for the mounting hole locations).
4 Insert the five mounting screws that attach the motherboard to the chassis.
Partially tighten each screw before completely tightening any one screw. Do not overtighten the screws; doing so
could damage traces on the motherboard.
5 Replace the coverplate on the unused DVI port with the two screws you removed earlier (see page 17 ).
6 Replace the power supply (see page 42 ).
Now you are ready to replace the remaining motherboard components to complete the motherboard installation.
To replace motherboard components
1 Replace the following cables to the motherboard (for the location of each connector on the motherboard, see
Figure 5 on page 20 and Figure 6 on page 21):
•
Reset button cable
•
Power button cable
•
24-pin power cable. The cable connector is keyed to fit only one way.
•
4-pin power cable. The cable connector is keyed to fit only one way.
•
Hard disk drive data cable
•
DVD drive data cable
•
Chassis fan cable
•
UIB cable (USB)
•
Front panel USB port cable (USB)
2 Reassemble the FC Solo (see page 50 ).
Replacing parts on the motherboard
This section describes how to remove and replace the DIMM(s), CPU, and battery on the motherboard. Before you
perform any of these procedures, shut down and open the FC Solo (see page 22 ).
CAUTION
Be sure to fit the motherboard Ethernet connectors under the metal grounding tabs in the cutouts.
Failure to position the grounding tabs correctly may result in permanent damage to the motherboard
and power supply.