EFI Fiery Central Solo, Service Manual, Page: 50 / 72

50 Service Guide: Fiery Central Solo for KM
Service Procedures
2 Place the bracket inside the chassis and secure it using the three screws that you removed earlier.
3 Attach the power and data combination cable to the back of the DVD drive.
4 Reassemble the FC Solo and verify functionality (see page 50 ).
5 If you installed a new DVD drive, make sure to reset the system date and time (see page 30 ).
Restoring and verifying functionality after service
Before you leave the customer site, make sure that you complete the following steps. If you cannot complete a step,
determine the reason and correct the problem before continuing. For more information, see “Troubleshooting” on
page 57.
To reassemble the FC Solo and verify functionality
1 Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables inside the FC Solo, make sure that:
•
Cables are securely installed after routing cables
•
Cable routing does not interfere with the operation of internal components nor interfere with removing or
replacing components
•
Cables are not tangled nor looped around internal circuit boards, or components (such as capacitors and
resistors)
•
Cables do not lie on or against any internal heating element
•
Cables do not interfere with opening or closing FC Solo panels
•
Cable slack is secured with a tie-wrap
2 Restore the FC Solo to the upright position.
3 Replace any panels that you removed earlier, as described on page 23 .
4 Connect the power cable to the FC Solo.
5 Connect to the network.
6 Ask the network administrator to download a test job over the network.