EFI Fiery Central Solo, Service Manual, Page: 23 / 72

23 Service Guide: Fiery Central Solo for KM
Service Procedures
4 Place the FC Solo on a flat surface. Attach an ESD wrist strap before handling internal parts (see “Precautions” on
page 7).
5 Carefully position the FC Solo so that it is resting on its side and the internal components are facing up.
Place removed components on a grounded, antistatic surface.
To remove and replace the side panel
1 Shut down the FC Solo (see page 22 ).
2 Remove the two screws that attach the side panel to the back of the chassis.
Set aside the screws so that you can replace them later.
3 Slide the side panel toward the connector panel.
It may help to use the palm of your hand to press down on the side panel as you slide it.
4 Lift the side panel off the chassis.
Figure 7: Removing/replacing the side panel
Note: Before you replace the side panel, make sure the top and front panels are installed.
5 To replace the side panel, fit the front edge of the panel under the front panel, and then slide the side panel in place.
Replace the screws that you removed earlier.
Make sure not to damage cables as you replace the panel. Fold all cables inside the chassis before closing the panel
against the chassis.
1 Side panel
1