EFI Fiery Central Solo, Service Manual, Page: 41 / 72

41 Service Guide: Fiery Central Solo for KM
Service Procedures
9 Install the motherboard in the chassis (see page 34 ).
10 Replace the power supply (see page 44 ).
11 Replace the motherboard components (see page 35 ).
12 If you installed a new CPU, configure the time and date in Setup (see page 30 ).
Chassis fan
A fan mounted inside the chassis blows air out of the FC Solo to cool components. The chassis fan runs continuously
when the system is on. You should hear the chassis fan start as soon as you power on the FC Solo. If you do not hear
the chassis fan, there may be a faulty power connection (see Figure 6 on page 21 ).
The following procedures describe how to remove and replace the chassis fan.
To remove and replace the chassis fan
1 Shut down and open the FC Solo (see page 22 ).
To access the chassis fan, you must remove the side panel.
2 Remove the fan cable from its motherboard connector.
3 Remove the four screws that attach the chassis fan to the chassis, and then remove the fan.
Set the screws aside so that you can replace them later.