Edge-Core ES3528MV2, Management Manual

Page: 687 / 1480

C
HAPTER
18
| Using the Command Line Interface
Entering Commands
– 687 –
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
Table 42: Configuration Command Modes
Mode Command Prompt Page
Access
Control List
access-list arp
access-list ip standard
access-list ip extended
access-list ipv6 standard
access-list ipv6 extended
access-list mac Console(config-arp-acl)
Console(config-std-acl)
Console(config-ext-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-mac-acl) 970
952
952
958
958
964
CFM ethernet cfm domain Console(config-ether-cfm) 1325
Class Map class-map Console(config-cmap) 1184
ERPS erps domain Console(config-erps) 1095
Interface interface {ethernet port |
port-channel id | vlan id }
Console(config-if) 976
Line line {console | vty} Console(config-line) 729
MSTP spanning-tree mst-configuration Console(config-mstp) 1072
Policy Map policy-map Console(config-pmap) 1188
Time Range time-range Console(config-time-range) 763
VLAN vlan database Console(config-vlan) 1131