Edge-Core ES3528MV2, Management Manual

Page: 1371 / 1480

C
HAPTER
42
| OAM Commands
– 1371 –
show efm oam
remote-loopback
interface
This command displays the results of an OAM remote loopback test.
S
YNTAX
show efm oam remote-loopback interface [ interface-list ]
interface-list - unit / port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-28)
C
OMMAND
M
ODE
Normal Exec, Privileged Exec
E
XAMPLE
Console#show efm oam remote-loopback interface 1/1
Port OAM loopback Tx OAM loopback Rx Loss Rate
---- --------------- --------------- ---------
1/1 10000 9999 0.01 %
Console#
show efm oam
status interface
This command displays OAM configuration settings and event counters.
S
YNTAX
show efm oam status interface [ interface-list ] [ brief ]
interface - unit / port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-28)
brief - Displays a brief list of OAM configuration states.
C
OMMAND
M
ODE
Normal Exec, Privileged Exec
E
XAMPLE
Console#show efm oam status interface 1/1
OAM information of Eth 1/1:
Basic Information:
Admin State : Enabled
Operation State : Operational
Mode : Active
Remote Loopback : Disabled
Remote Loopback Status : No loopback
Dying Gasp : Enabled
Critical Event : Enabled
Link Monitor (Errored Frame) : Enabled