Edge-Core ES3528MV2, Management Manual, Page: 83 / 1480

C
HAPTER
2
| Initial Switch Configuration
Basic Configuration
– 83 –
S
ETTING AN
IP
A
DDRESS
You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
◆ Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet
as the switch, you will also need to specify the default gateway router.
◆ Dynamic — The switch can send IPv4 configuration requests to BOOTP
or DHCP address allocation servers on the network, or can
automatically generate a unique IPv6 host address based on the local
subnet address prefix received in router advertisement messages. An
IPv6 link local address for use in a local network can also be
dynamically generated as described in "Obtaining an IPv6 Address" on
page 87 .
◆ The current software does not support DHCP for IPv6, so an IPv6 global
unicast address for use in a network containing more than one subnet
can only be manually configured as described in "Assigning an IPv6
Address" on page 84 .
M
ANUAL
C
ONFIGURATION
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and
management stations that exist on another network segment. Valid IPv4
addresses consist of four decimal numbers, 0 to 255, separated by periods.
Anything outside this format will not be accepted by the CLI program.
N
OTE
:
The IPv4 address for this switch is obtained via DHCP by default.
A
SSIGNING AN
IP
V
4 A
DDRESS
Before you can assign an IP address to the switch, you must obtain the
following information from your network administrator:
◆
IP address for the switch
◆
Network mask for this network
◆
Default gateway for the network
To assign an IPv4 address to the switch, complete the following steps
1.
From the Global Configuration mode prompt, type “interface vlan 1” to
access the interface-configuration mode. Press <Enter>.
2.
Type “ip address ip-address netmask ,” where “ip-address” is the switch
IP address and “netmask” is the network mask for the network. Press
<Enter>.
3.
Type “exit” to return to the global configuration mode prompt. Press
<Enter>.