Edge-Core ECS4610-24F, Management Manual, Page: 937 / 1154

C
HAPTER
39
| Multicast Filtering Commands
IGMP (Layer 3)
– 937 –
IGMP (L
AYER
3)
This section describes commands used to configure Layer 3 Internet Group
Management Protocol (IGMP) on the switch
.
ip igmp
This command enables IGMP on a VLAN interface. Use the no form of this
command to disable IGMP on the specified interface.
S
YNTAX
[ no ] ip igmp
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (VLAN)
Source Address Indicates the source address of the multicast service, or displays
an asterisk if the group address has been statically assigned.
VLAN Indicates the MVR VLAN receiving the multicast service.
Forwarding Port Shows the interfaces with subscribers for multicast services
provided through the MVR VLAN. Also shows the VLAN through
which the service is received. Note that this may be different from
the MVR VLAN if the group address has been statically assigned.
Table 119: show mvr members - display description (Continued)
Field Description
Table 120: IGMP Commands (Layer 3)
Command Function Mode
ip igmp Enables IGMP for the specified interface IC
ip igmp last-member-
query-interval
Configures the frequency at which to send query
messages in response to receiving a leave message
IC
ip igmp max-resp-interval Configures the maximum host response time IC
ip igmp query-interval Configures frequency for sending host query messages IC
ip igmp robustval Configures the expected packet loss IC
ip igmp static-group Configures the router to be a static member of a
multicast group on the specified VLAN interface
IC
ip igmp version Configures IGMP version used on this interface IC
clear ip igmp group Deletes entries from the IGMP cache PE
show ip igmp groups Displays information for IGMP groups PE
show ip igmp interface Displays multicast information for the specified
interface
PE