Edge-Core ECS4610-24F, Management Manual

Page: 633 / 1154

C
HAPTER
25
| SNMP Commands
– 633 –
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP Logging: Disabled
Console#
snmp-server enable
traps
This command enables this device to send Simple Network Management
Protocol traps or informs (i.e., SNMP notifications). Use the no form to
disable SNMP notifications.
S
YNTAX
[ no ] snmp-server enable traps [ authentication | link-up-down ]
authentication - Keyword to issue authentication failure
notifications.
link-up-down - Keyword to issue link-up or link-down notifications.
D
EFAULT
S
ETTING
Issue authentication and link-up-down traps.
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to configure
this device to send SNMP notifications, you must enter at least one
snmp-server enable traps command. If you enter the command with
no keywords, both authentication and link-up-down notifications are
enabled. If you enter the command with a keyword, only the
notification type related to that keyword is enabled.
◆
The snmp-server enable traps command is used in conjunction with
the snmp-server host command. Use the snmp-server host command
to specify which host or hosts receive SNMP notifications. In order to
send notifications, you must configure at least one snmp-server host
command.
◆
The authentication, link-up, and link-down traps are legacy
notifications, and therefore when used for SNMP Version 3 hosts, they
must be enabled in conjunction with the corresponding entries in the
Notify View assigned by the snmp-server group command.
E
XAMPLE
Console(config)#snmp-server enable traps link-up-down
Console(config)#