Edge-Core ECS4610-24F, Management Manual

Page: 783 / 1154

C
HAPTER
30
| Interface Commands
– 783 –
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
◆ Cable diagnostics are performed using Digital Signal Processing (DSP)
test methods.
◆ This cable test is only accurate for cables 7 - 140 meters long.
◆ The test takes approximately 5 seconds. The switch displays the results
of the test immediately upon completion, including common cable
failures, as well as the status and approximate length of each cable
pair.
◆ Potential conditions which may be listed by the diagnostics include:
■
OK: Correctly terminated pair
■
Open: Open pair, no link partner
■
Short: Shorted pair
■
Not Supported: This message is displayed for any Fast Ethernet
ports that are linked up, or for any Gigabit Ethernet ports linked up
at a speed lower than 1000 Mbps.
■
Impedance mismatch: Terminating impedance is not in the
reference range.
◆ Ports are linked down while running cable diagnostics.
E
XAMPLE
Console#test cable-diagnostics dsp interface ethernet 1/10
Console#show cable-diagnostics dsp interface e 1/10
Port Type Link Status Pair A (meters) Pair B (meters) Last Update
-------- ---- ----------- ---------------- ---------------- -----------------
Eth 1/10 GE Up OK (21) OK (21) 2009-11-13 09:44:19
Console#
test loop internal
This command performs an internal loop back test on the specified port.
S
YNTAX
test loop internal interface interface
interface
ethernet unit / port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-24)
C
OMMAND
M
ODE
Privileged Exec