Eddyfi Technologies TSC U41, User Manual

Page: 24 / 72

System Overview
12 | www.eddyfi.com
the Config Cog.
Figure 1-15
Operation with ROV - Topside configuration
A dialogue similar to the one shown below should appear.
Figure 1-16
Operation with ROV - Topside configuration
If using ethernet through the ROV, untick Enable Serial.
If using serial communications direct or through a ROV multiplexing system, tick Enable Serial,
then specify protocol and baud rate using the Mode and Speed (bps) selections.
If using long umbilical cable direct from Topside Unit to U41 subsea bottle, select
To apply the changes, press the Green Arrow button. This will close the dialogue, restart the
Topside Unit and show the Instrument Connection dialogue once again. There will be a delay
before the Topside Unit instrument reappears in the dialogue. Press Cancel to close the
Instrument Connection dialogue.
U41 subsea bottle configuration
From the Backstage/General tab, configure the U41 bottle by pressing the Connect button.
Figure 1-17
Operation with ROV - Subsea bottle configuration
Then from the dialogue like the one shown below, select the ‘U41 – Ethernet’ instrument and
click the Config Cog.