Ecolab 417102214, User Manual

Page: 82 / 182

417102214_EDPL_V60.docx 82 Rev. 1.12.11
9.3 Button/switch functions
Key Description
Fig. 9.3
Master switch (on/off switch)
Fig. 9.4
MENU/EXIT function for entering and exiting the menu levels
(Keep the buttons pressed together)
Increase settings
Decrease settings
Fig. 9.5
Start the pump
Stop the pump
ENTER key to confirm set values
Fig. 9.6
Test function (continuous operation)
9.4 Display indicators
Display
Description
Signal to indicate that the pump is running; the indicator in the top right of the display goes
through a complete cycle with every stroke of the pump. The letter in the display stands for the
active metering mode setting
(s = standard, m = medium; l = low, v = variable, see chapter 10.2 “ Metering mode ”)
Display of the current metering frequency or rate setting in %
Level signal present (flashing display = level pre-warning, display visible continuously = empty
signal), see chapter
7.2.5.1.1 “ Installation of the suction pipe ” or chapter 10.4.9 „ Configuration of the
level contact ”.
Metering lock enabled, see chapter 7.2.5.4 “ Installation of the metering lock ” or chapter 10.4.8
“ Configuration / Metering lock ”.
Malfunction present, see chapter 12.1 ” Fault signals ”.
Internal
Operating mode Internal, see chapter 10.3.2 ” Operating mode / Internal ”
xxx /min Operating mode Internal, strokes/ min indication
see chapter 10.3.2.1 “ Selection ” xx % Operating mode Internal, display in %
x.xx l/h Operating mode Internal, l/h indication
Pulse Operating mode Pulse, see chapter 10.4.4 “ Operating mode / Pulse ”
x..xx mA Operating mode Current, x – xx mA, see chapter 10.3.4 “ Operating mode / Current ”
Batch Operating mode Batch, see chapter 10.4.15 “ Configuration / Batch ”
OFF Pump is in OFF mode (must be switched on), see chapter 9.4 “ Displays ”
V60+
Dongle box connected, see chapter 8 “ Upgrading to V60
PLUS
”
V60++
Dongle box and OGM
PLUS
connected, see chapter 8.1.2 “ Installation of oval gear meter ” or chapter
10.4.12 “ Configuration / Oval gear meter ”.
Pulse memory enabled, the icon appears as soon as the pulse memory has been enabled in the
configuration; if the icon is flashing, the pump processes the saved pulses immediately, see chapter
10.4.11 “ Configuration / Pulse memory ”.
c!
Please perform a calibration! This icon appears when metering mode (see chapter 10.2 “ Metering
mode ”) or the maximum metering capacity (see chapter 10.4.5 “ Configuration / Max. metering
capacity ”) if the pump has been re-adjusted, which means that calibration is imperative in order to
adapt the displays and conversion principles accordingly. The icon disappears after automatic
calibration has been performed, see chapter
10.5 “ Calibration ”

Calibration performed correctly
Alarm Alarm state, see chapter 12.1 “ Fault signals ”