Ecolab 417102214, User Manual

Page: 94 / 182

417102214_EDPL_V60.docx 94 Rev. 1.12.11
10.4.7 Configuration / Auto start
This function determines whether the pump is set to 'OFF' when the mains connection is re-
established following a power cut or if the pump should immediately recommence functioning
in the configured operating mode.
10.4.7.1 Selection
Fig. 10.28
- Auto start is inactive.
The pump goes to 'OFF' when the
mains voltage is connected.
(Default setting)

Auto start is active.
When the mains voltage is connected,
the pump starts functioning in the
configured operating mode.
10.4.8 Configuration / Metering lock
If the metering lock is enabled, the pump only functions if an external enable contact is
connected to plug II between PINs
3 + 4 (see chapter 7.2.5.4 “ Installation of activation via a
metering lock ”) regardless of which operating mode is set.
10.4.8.1 Selection
Fig. 10.29
- Metering lock query inactive.
(Default setting)

Metering lock query active.
10.4.9 Configuration / Level contact
This function specifies whether an open or a closed contact at the level input (plug I, see
chapter
7.2.5.1 “ Pin configuration for slot I (3-pin) - Input for level pre-warning and empty
signal ”) is regarded as level OK.
10.4.9.1 Selection
Fig. 10.30

= Contact open:
Level not OK (empty)
Contact closed:
Level OK (full)
(Default setting)

= Contact closed:
Level not OK (empty)
Contact open:
Level OK (full)