ECO-MATIC MEMS36USA, Installation & Operation Instructions

Page: 20 / 31

20
Controls and Display Panel
The rate at which your ECO-matic produces (sani tizer for your pool) varies (see belo w) and is
indicated on the DIGITAL DISPLAY (Eg: 90 – 100 or in winter mode 75 – 85).
There are two lights on the Cont rol Panel – LED 1 and LED 2 – wh ich will indicat e whether the
system is working as intended or whether there may be faulty or damaging operating conditions (such
as low salt levels). If these warnings are ignored, the Unit will either
Cut-Out OR otherwise, continued
operation will result in damage to the ‘Cell’.
Start Up
1. Turn the POWER ON (first time only). Powe r setting “| ”. Switch f ilter pump ON (ECO-matic
also gets power). ECO-matic power switch can then be left ON and filter power control will also
control the ECO-matic.
2. The unit will enter a START- UP PHASE (which will repeat itself each time the system power s
up). The STANDBY light will be ON, but there will be no ‘Cell’ output (sanitizer production).
3. After the Start-Up delay, the DISPLAY shoul d indicate around 90 – 105 ( unless set in t he
Winter Mode). With the correct amount of salt added and dissolved, both LED 1 and LED 2 will
be GREEN. If LED 2 is RED, there is insufficient salt in the pool. S ee the table on the page 6
for other installation related problems.
Digital Display
The DIGITAL DISPLAY indicates how the ECO-matic is pe rforming, compared to its maximum
design output.90(%) – 100(%) range is common. Normal Winter Mode readings 75 – 85.