ECO-MATIC MEMS36USA, Installation & Operation Instructions

Page: 19 / 31

19
Note: Never add salt in order to increase sanitizer level. Only add salt, as necessary, to maintain
minimum salt level.
The Amount of Sanitizer Produced by ECO-matic Depends Upon:
a) The daily operating time of the equipment (pump/filter and ECO-matic).
b) The
System Control setting (high or low)
c) The settings of the ORP Sensor
d) The condition of the ECO-matic ‘Cell’ (clean or dirty)
The rate of sanitizer production will decrease as the ‘Cell’ accumulates scale (calcium, etc), or if the
salt level in the water decreases and, in time, as the ‘Cell’ nears the end of its life.
Note: Your Test Kit is your ONLY INDICATOR of whether your ECO-matic is producing sufficient,
too little, or too much sanitizer for your pool.
ORP Sensor
If your ECO-matic is producing TOO MUCH SANITIZER, reduce the ORP set point of your Chemistry
Controller
If your ECO-matic is producing TOO LITTLE SANI TIZER, increase the ORP set point, or chec k
stabilizer/conditioner level an d phosphate contamination. Also refer to your ORP (che mistry
Controller) owners manual.
Manual Control
If your ECO-matic is producing TOO MUCH SANITIZER, turn the system control down.
If your ECO-matic is producing TOO LITTLE SANITIZER, turn the system control up.