ECKELMANN UA 410 L Case Controller, Operating Instruction

Page: 38 / 92

Installation and Startup of UA 410 L
32 Firmware V1.50 - Doku 2.0 06. April 2016
5.5 Terminal assignment for 230 V AC power supply
Warning - hazardous electrical voltage!
Danger of electric shock! BEFORE and AFTER
connection it must checked
that the 230 V AC supply cable is off load !
The power supply cable is connected to the case controller using the right hand terminal block PE/L/N:
ZNG: 116 030 DEF1
230 V AC
11 VA
N
L
PE
50 - 60 Hz
10 1
D32 D31 D22 D21 D12 D11
73 74 43 44 63 64 53 54
2 1 3 4
CAN-GND
CAN-LOW CAN-HIGH
SHIELD
D42 D41
GND
AO2
GND
AO1
5
0
2
3
1
4 6
7
8
9
5
0
2
3
1
4 6
7
8
9
N L PE
CAN-BUS
ADDRESS
1..99
31 32 30 29
15 16 18 25 26 28 35 36 38
The case controller can now be supplied with power. If power is being received the active lamp (LIFE LED)
flashes for approximately 10 seconds following actuation. If the case controller is also connected to the CAN
bus, then the CAN bus LED flashes. For more details on the status LEDs see chapter 5.5.1.