ECKELMANN UA 410 L Case Controller, Operating Instruction

Page: 37 / 92

Installation and Startup of UA 410 L
31 Firmware V1.50 - Doku 2.0 06. April 2016
5.4 Setting the controller type
Caution: data loss!
All parameters are reset to their factory settings if the controller type is changed or due to a first start
(see chapter 5.8)!
Setting controller type
The required controller type is set via the DIP switch S3 by adjusting the coding switches 1..8 with a thin screw­
driver (D = 2 mm) through a hole in the case cover. Depending on the set controller type, the respective functio­
nalities are then displayed or hidden in the menu of the controller.
Warning - hazardous electrical voltage!
Danger of electric shock!
DIP switch S3 must be changed in voltage-free state only. Settings be­
come effective on the case controller until the controller is briefly switched off and back on!
Controller type and master/slave mode DIP Switch S3
(Coding Switch positions 1 to 8)
1 2 3 4
1)
5 6 7 8
UA 410 L OFF OFF OFF OFF OFF OFF OFF OFF
Only part of the overall functions and parameters contained in the case controller are available when selecting a
specific controller type.
Operation of the controller with a unsupported DIP switch setting is not allowed. In the case of any
setting of coding switch combinations that are not present in the list, UA 410 L is automatically app­
lied as controller type and an alarm signal is created. In the event of change of the controller type, all
parameters are reset to their factory settings.