ECKELMANN UA 410 L Case Controller, Operating Instruction

Page: 18 / 92

Application of UA 410 L
12 Firmware V1.50 - Doku 2.0 06. April 2016
3.2 Controller type
Ttemperature recording controller UA 410 L Case Controller:
Controller type Application
UA 410 L Temperature Data Logging Controller for maximum 10 temperature sensors
(with the option of on-off control/defrosting of five independent refrigeration points for the first five sensors).
For definition of the basic control behaviour, only one controller type can always be selected that is set using the
DIP switch S3. Only the controller type "UA 410 L" is available for the UA 410 L:
Set controller type DIP switchS3
Position of Coding Switch 1 to 8
1 2 3 4 5 6 7 8
UA 410 L OFF OFF OFF OFF OFF OFF OFF OFF
Operation of the controller with a unsupported DIP switch setting is not allowed. In the case of any
setting of coding switch combinations that are not present in the list, UA 410 L is automatically ap­
plied as controller type and an alarm signal is created.
In the event of change of the controller type, all parameters are reset to their factory settings.
For further information, see chapter 5.4 - Controller type setting.
Selection of controller type defines the controller properties and basic controller settings.
The UA410 L Temperature Data Logging Controller can be operated by:
‐ Host computer e.g. via network / modem with connection to the system centre / store computer,
‐ the system centre, a store computer or an operator terminal,
‐ a local operator interface BT 300 via the DISPLAY interface on the controller or
‐ a notebook (PC) with the PC-software LDSWin connected via USB.
3.2.1 Version update
The case controller is supplied with the current firmware, ready for operation. Future software versions can be
loaded into the case controller as required by means of a firmware update, and thus updated.
Danger data loss! In some cases a change of firmware version can lead to the loss of all the set­
points in the case controller.
As a precaution, the settings must be backed up by saving them to the LDSWin PC software,
prior to the update. After the firmware update the backup settings can be reloaded into the controller
from LDSWin.
A software update is only to be carried out by trained staff or factory-side by the manufacturer.
More details on firmware updates can be found in chapter 5.10.