10
Installation Guide
10
tel - 1-800-477-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
EMUBCAMKIT
Universal Quad View Camera Kit
Installation (continued)
Front
Cam1-in
Rear
Cam2-in
Left
Cam3-in
Right
Cam4-in
Video-out
Reset
Step 5
For each camera; plug in a Camera Input
Adapter (1) into the video interfaces camera
input. Align the arrows on the Camera Input
Adapter and Camera Extension Cable (2) and
connect the cables.
Step 6
DIP switches 1-2-3-4 on the side of the
module correspond to Camera Inputs 1-2-3-4.
For any camera that is facing towards the rear
of the vehicle, set the DIP switch to the ON
(UP) position. This will “mirror” the video so it
is viewed correctly on the monitor.
DIP switch 5 sets the Video Output Type: See
page 15 for setting video output once unit is
installed.
1
2
1 2 3 4 5
ON
Yellow- Connect to Co12V
Red - Connect to Sw12V
Black - Connect to Ground (-)
Pink - Camera 4 Trigger (+)
Orange - Camera 3 Trigger (+)
Green - Camera 2 Trigger (+)
White - Camera 1 Trigger (+)
8-Pin Power/Trigger Plug
Remote IR Receiver
Camera Triggers 1-4
Display Mode Switch
Micro SD Card Slot
DIP Switches
Required for DVR Recording.
128GB Max Card Size
Switches between cameras
and display modes.
When +12V is applied, displays
corresponding camera.
Receives signal from the
wireless remote control.
DIP switches 1-4
correspond to Cameras 1-4
When in the OFF(DOWN) postion, the camera image will be normal (Non-Mirrored).
Non-Mirrored should be used for any forward facing cameras.
When in the ON (UP) postion, the camera image will reversed (Mirrored).
Mirrored should be used for any rear facing cameras.
DIP switch 5
sets Video Output Signal Type: ON (UP) is Standard (CVBS)
OFF (DOWN) is Analog High Definition (AHD)
ON (UP) = Mirrored
OFF (DOWN) = Non Mirrored