15
Installation Guide
15
tel - 1-800-477-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
EMUBCAMKIT
Universal Quad View Camera Kit
Trigger Wires
Setting the Video Output
The four trigger wires on the 8-pin Power/
Trigger plug can be uses to manually activate
each of the four cameras. When a trigger wire
re12V, the corresponding camera will
be displayed.
These can be connected to switches to
instantly turn on a selected camera.
The video interface can output four different
video signals: AHD 30 fps, AHD 25 fps, CVBS
NTSC and CVBS PAL. The default setting on
initial power up is AHD 30 fps. To change the
output, flip DIP switch 5 ON (UP) then OFF
(DOWN) one time. After 25 seconds the video
output will switch to AHD 25 fps. Flipping DIP
switch 5 a second time will change the output
to CVBS NTSC after 25 seconds. This is the
most common setting. Flipping DIP switch 5
a third time and waiting 25 seconds will set
CVBS PAL.
Pink - Camera 4 Trigger (+)
Orange - Camera 3 Trigger (+)
Green - Camera 2 Trigger (+)
White - Camera 1 Trigger (+)
8-Pin Power/Trigger Plug
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
DEFAULT SETTING:
AHD 30 FPS
DIP 5 ON/OFF ONE TIME:
AHD 25 FPS
DIP 5 ON/OFF SECOND TIME:
CVBS NTSC
DIP 5 ON/OFF THIRD TIME:
CVBS NTSC
WAIT 25 SECONDS
WAIT 25 SECONDS
