Echoflex Installation Guide
Elaho Vacancy Sensor
•
Install the sensor where it cannot easily sense movement in areas
outside of the intended space, such as hallways, glass partitions, or
adjacent rooms. If the installation location cannot avoid these
conditions, portions of the lens can be masked to block the sensor
view of these undesired areas. Reference
Lens Masking on page 9
.
Parts and Supplies
The following parts and supplies are included with the Vacancy Sensor
ordered:
•
Soft ceiling tile adaptor
•
2 each screws, 6-32 x 3/4” and 1 3/4”
•
EchoConnect and ESD ground wire pigtails
•
3 lens masks
Note:
Follow all local code requirements for terminating wire.
Use appropriately sized wire nuts (not provided) to secure each
termination.
The EchoConnect pigtail is only required when the sensor is installed in
series with other stations or sensors. If you are not continuing the data
run, direct termination on the control board is recommended.
Installation
The Vacancy Sensor is provided with a twist-lock mounting plate that can be
mounted to a junction box, finished ceiling, or soft ceiling tile. Determine the
installation method and follow the detailed instructions provided:
•
Junction Box Installation on the next page
•
Soft Ceiling Tile Installation on page 5
•
Lens Masking on page 9
Elaho Vacancy Sensor
Page 3 of 12
Echoflex Solutions, Inc.
