EBS-6200
Printer User's Manual
Chapter 4 - Operating the Printer
#1.0
73
20091020
For example:
This is the right time to replace the empty bottle with a full one.
In some emergency situations the
INK LACK
message can occur although the ink bottle is not empty
or the
SOLVENT LACK
message although the solvent bottle is not empty. The occurrence of such
messages indicates some inefficiency in the ink (solvent) suction system.
In order to avoid trouble while replacing empty ink (solvent) bottles, follow the procedure
given below:
1.
Remove the empty bottle from the container - the following message can be displayed on the
terminal:
INK:
SOLVENT:
this me
le is
the bottle unsuitable
NO BOTTLE
for the bottle of ink
or
NO BOTTLE
for the bottle of solvent.
2.
Place a new sealed bottle (but do not insert a suction pipe into the bottle). One or more messages
may be displayed. If this is the proper bottle, that is, a new bottle that has never been used (or
approved) before, the following message should appear at first:
VERIFYING BOTTLE:
WAIT 10 SECONDS PLEASE
3.
If the
BOTTLE ACCEPTED
message is displayed within 10 seconds,
ans that the bott
right for a given printer. Remove the bottle and unseal it. Then insert a suction pipe tipped with
a filter into the bottle and screw the bottle in (the
NO BOTTLE
message can occur at that time).
4.
Put the bottle in place - if no bottle error occurs, the normal status indication should be displayed
in the printer status window.
With this the replacement procedure finishes.
NOTE:
•
will consider
Do not refill an empty bottle with ink (solvent), as
IMS
anyway. Every new bottle is assigned a time limit and after the expiry of the time limit the
bottle is considered unsuitable even if it is not empty - see section
Time vs. Solvent Consumption Time Limit
. During normal operation of the printer the bottle
is always emptied before the time limit expires.
•
The empty bottle alarm cannot be cleared with the clear alarm
CRL.
ALARM
key. The alarm is cleared
•
rm with the clear alarm key.
suc
Ens
•
Do not re
validated by the system (about 10 seconds).
•
Every bottle can be used only in the printer where it has been approved by
IMS
. The approved
bottles must not be moved to other printers or used to refill other bottles. The bottle approved
should remain in the printer container until the ink is consumed.
automatically only after the empty bottle has been replaced with a new one and the new bottle
has been approved by
IMS
.
If no new bottle has been approved within 30 minutes since the empty bottle alarm was
indicated, the printing ceases and the following message is displayed:
REPLENISHMENT ERROR
.
Replace the bottle with a new one and clear the ala
•
The above message is also displayed, if the printer is unable to suck any ink (solvent) after
a new bottle has been supplied and approved (because the user has forgotten to put the
king pipe into the bottle, an ink system failure has occurred or for another reason).
ure that ink (solvent) is sucked properly and clear the alarm with the clear alarm key.
move the bottle while it is being
!
Summary of Contents for EBS-6200
Page 1: ...EBS 6200 USER S MANUAL Ink Jet technology for the future...
Page 2: ......
