EBS Ink-Jet Systems EBS-6200, User Manual

Page: 15 / 124

EBS-6200
Printer User's Manual
Chapter 2 - Installing the Printer
#1.0
13
20091020
d). Service tool: a template
e). Service tool for shaping Ø 3 Teflon (PTFE) pipe tips.
NOTE:
•
The above list shall not be considered a specification of accessories (to be) delivered together
wi
Th
ountry to country.
for adjusting the distance between the gutter and nozzle.
th a printer or printing system.
•
e list of accessories may vary from c
!
2.3.2. Preparatory Steps
In order to prepare a new or transported printer to operation, you should perform the following
operations:
´
Place the unit in a room that is free from vibration, shocks, dust, smoke, soil, aggressive or
inflammable vapours and gases.
!
NOTE: The room shall meet the following requirements:
Environmental conditions: operating temperature from +5
°
C to +40
°
C,
at the max. frequency of 10Hz,
´
´
Secu
´
relative humidity up to 90% without condensation.
Mechanical requirements: max. vibration 1g
max. shocks of 1g over the maximum of 2ms.
´
Ensure that free and easy access to the unit is
provided.
´
Place the printer on a 0.7 to 1.1 m high horizontal
table or original rack for
EBS-6000
series
printers for convenience.
Check for mechanical damages to the unit, head
and connecting hose, which might have been
caused during carriage.
re the print head holder in a convenient
position.
Secure the print head in the holder in any required
position.
´
Install the photo detector in clamps fixed to the
head holder or in any other place which would be
most suitable for the object under print.
Fig. 2.3.2.1.
Head holder
Photo detector holder
Head axis
37 mm
Fig. 2.3.2.2.
Fixing the standard head
holder to a conveyor
stable
in contact with the conveyor.
2xM5
O ten the head holder on a N TE: If conveyor vibration is too strong, it would be better to fas
rack or on a wall, provided that the rack and the wall are not
!