EBS Ink-Jet Systems EBS-6200, User Manual

Page: 103 / 124

EBS-6200
Printer User's Manual
Chapter 6 - Service and Maintenance
#1.0
101
20091020
m). screw tight nut of the
n). only after all service operations have been completed
new ink filter to the ink pump angle connector,
should the
V
key be pressed. Then
the following message is displayed:
FILTER CHANGED,
ink will be switched on !!!!!
,
and the r t to confirm follows,
o). after y confirmed that the cement is complete, the pr w minutes
to ge to the rea therefore the following message is displayed:
WAIT 4,5 minutes Then th ess is indicated with t R CHANGE
message the disp
p). press the key eturn to t and
eq
ou ha
t ba
on
ues
ve
ck
filter repla
dy state and
inter needs a fe
e end of the proc he END OF FILTE
lay,
V
to r he comm menu.
!
This sleeve must be
replace
a new
one eac e the ink
filter is changed !!!
OUT
d with
h tim
IN
R3
Main ink filter
Ink level
Fig. 6.1.2.
Contaminations may get into the printer’s ink system during replacement of the main ink filter.
Therefore it is recommended that the filter replacement be followed by a slightly shorter, about 10-
minute ink filtering procedure similar to that described before.
Replacing Ink Filter Inside the Gun
Replace (clean out) the ink filter inside the head gun by following the steps below – see
Fig. 6.1.3
):
•
wait until impurities deposit on the filter and select the V0 OFF command (or press the
INK O xternal panel) in order to stop the flow of ink to the head; the V0 lamp
on the out,
•
wash the nozzle with solvent,
•
use a size 4 open ended spanner to unscrew sleeve , which is used to hold down the tube that
supplies ink to the gun. Use size 8 open ended spanner to hold up the filter fitting, if need be,
•
pull out the unscrewed pipe and the fixing sleeve ,
•
using an open ended spanner size 8 unscrew the filter fitting for gun , remove the filter fitting
from the gun and wash with solvent,
•
remove the ink filter , insert a new one in the proper direction
N/OFF key on the e
internal panel goes
or wash the existing filter
thoroughly if possible,