EBS-6200
Printer User's Manual
Chapter 7 - Storage and Carriage
114
200
Step
Message
Description
5
- Connect full solvent bottle
to the ink pump input
- Press ENTER ...
Undo the retaining nut from connector pipe
of
the solvent pump and then detach the solvent
bottle tube from the connector pipe. Insert the end
of connector pipe PL3 (detached from the solvent
bottle) into tube PL4 (prepared in step
1
), and
attach that tube to input connector pipe
of the
ink pump angle connector.
V
button. Then, the ink system rinsing
procedure starts.
Make sure that the solvent bottle is full of solvent. If
it is partially empty, replace it with a new full one.
After the operation has been carried out, press the
6
- Wait for level of solvent
in bottle to fall to half
- Press ENTER ...
While the message is being displayed, solvent is
being pumped over to the empty bottle attached in
step
2
. The pressure stabiliser, ink pump and the
V0
,
V1
and
V3
valves are rinsed. Observe the level
of solvent in the solvent bottle and when the level
drops by half, press the
V
button.
7
- Wait until solvent bottle
is empty
After the message has been displayed, the solvent
flow path changes. The pressure stabiliser, ink
pump and the
V6
,
V5
and
V3
valves are rinsed.
- Press ENTER...
Continue observing the solvent level in the bottle at
this stage and when the level drops to zero press
the
V
button. This operation finishes the rinsing
procedure.
8
- Secure ink system according
- Wait for printer to switch off
- AttachTubesTo prev.
connections
- Press ENTER
After rinsing, the printer switches off automatically.
Make all the connections that were disconnected in
the previous steps (connect the tube going from the
ink tank to connector pipe
, the tube going from
ink filter to input connector pipe
of the ink pump
e
solvent bottle to connector pipe
of the solvent
pump).
to
Service Manual instructions
angle connector and the tube going from th
After the above procedure has been followed, the printer can be stored over the period of up to three
months. However, it must be prepared for storage in the same way as for carriage. A description of
how to prepare
EBS-6200
printers for carriage is given in
In order to prevent the memory back-up battery discharging, switch the printer on for about 8 hours at
least once a month to recharge the battery. The printer can be switched on
out switching the head
–
SER
h
drop and the following error messages may appear twice or three times after the unit has been
with
on as soon as the printer is switched on select the
FAST OFF
command from the submenu
VICE
.
If t e
EBS-6200
printer has not been used for a period of at least 2 weeks, ink pressure may
started:
INK PUMP TIME-OUT
or
INK PRESSURE DROP
. You can clear the alarm with the yellow
CRL.
ALARM
key and continue operating the unit as usual.
Allowable climatic and mechanical exposures:
•
shocks:
max. 1 g, max. 2 ms
.
•
storage
temperature
from -5
°
C to +50
°
C
,
•
relative
humidity
max. 90% without condensation
,
91020#1.0
Summary of Contents for EBS-6200
Page 1: ...EBS 6200 USER S MANUAL Ink Jet technology for the future...
Page 2: ......
