9
Functions in the display mode
The display mode contains six functions:
OVERVIEW
,
MAIN MENU
,
CONNECTION
TIME
, shortcut to
TEMP
menu and set point, shortcut to
LANGUAGE
menu and
STANDBY MODE
.
30 seconds after the last button press, the thermostat always returns to
display mode, irrespective of where in the menus you are. If you are ever
unsure of whether you are in the required menu or setting, you can always
let the thermostat return to display mode; no settings are then saved (if you
have not pressed to confirm), and you can start again from the beginning.
Overview
[press
3 s]
To quickly and easily gain an overview of the thermostat settings, press
for three seconds to activate the overview function. You can then
use and to browse through the thermostat settings. To return to
display mode, press or wait thirty seconds.
Main menu
[press
]
When the thermostat is in display mode, press to go to the main
menu. From the main menu, you can reach all settings (read more
about the main menu under the section for the selected operation
mode). To return to the display mode, wait thirty seconds or
EXIT
.
INTRODUCTION
Display mode
The display mode is the thermostat's "normal" mode; the most important
settings, statuses and functions are shown and set here. The display
shows, alternatingly, the set point and current values at the same time as
it always shows the operation mode and if the installation is switched on
or off. The set point is the desired value, whereas the current value is the
temperature or moisture status at this point in time.
PROGRAM
OPERATION MODE
SET POINT
ON or OFF
CURRENT VALUE A*
HEADING
CURRENT VALUE B*
CURRENT VALUE C*
* CURRENT VALUE A shows the temperature at sensor A and CURRENT VALUE B
shows the temperature at sensor B. CURRENT VALUE C shows whether moisture
is detected by sensor C. The current value is only shown for the sensors that are
installed and activated.
ON or OFF
SENSOR
RM 20.5
IDLE
PERSONAL
TMP +20.0
IDLE
HEAT
