EAW UMX.96, Owner'S Manual, Page: 139 / 208

EAW UMX.96 Owner’s Manual Touchscreen Interface
12-59
12.5.1.12 Crossover Editing – Advanced Routing View
In Advanced Routing View, each “way” of the multi-way crossover is created and displayed individually. Fig-
ure 12.5.5 shows the crossover’s edit screen. You can access all 12 bands of the Output Processor here.
Figure 12.5.5
Graph area Graph showing frequency response curves and gain for up to four bands
X-OVER IN Four numbered buttons that bypass the filters for that output
MUTE
Mutes that entire band In/Out
INV
Polarity invert 0/180 degrees
GAIN Output gain ±12 dB (Touch and Spin)
HP FILTER High-pass filter forms the LF end of the bandpass filter
LP FILTER
Low-pass filter forms the HF end of the bandpass filter
IN
Turns filter on In/Out
CORNER FREQ –3 dB frequency of the filter 20 Hz - 20 kHz (Touch and Spin)
FILTER TYPE Slope and characteristic of that filter Butterworth: 6, 12, 18, 24 dB/octave
Bessel: 6, 12, 18, 24 dB/octave
Linkwitz-Riley: 12, 24 dB/octave
(Touch and Spin)
Band Edit Select
Selects a band (1 of 12) for editing in the Selected Band Edit area. The last four
buttons selected are lit in the Band View Selection and the X-OVER buttons
across the top. The color will match the color of the curve being edited.
Band View Select
Select four bands for viewing in the graph area. These buttons also reflect in the
four X-OVER buttons across the top. The color will match the color of the curve on
the display. The Band Edit Selection is always one of the four buttons illuminated.
Note: The MUTE, INV, and GAIN shown in the crossover are the same controls found at the end of each out-
put leg. They are duplicated here for convenience.
CAUTION: If you are using the crossover as the primary crossover in a multi-way multi-amplified system, it
is dangerous to bypass the crossover filtering to any transducer that is not a cone speaker; i.e., compression
drivers. Compression drivers presented with full-range signals have very short lifetimes. Therefore, you will
always be presented with a confirmation dialog when disabling crossovers.