Eaton XN-312-GW-EC, Manual

Page: 43 / 131

4 XN-312-GW-EC gateway object dictionary
4.3 Device parameter area
XN-312-GW-EC gateway 07/20 MN050010-EN Eaton.com
39
4.3.6.1 Error codes
The error codes are shown under the CoE tab when using online communi-
cation; please refer to
￫ Section “12.7.4 ONLINE CoE XN-312-GW-EC
gateway”, page 92 and ￫ Section “12.6 Diagnostics messages”, page 87.
Byte 1 Byte 0
Sub-index
1
≦ n ≦ 254
B15 B14 B13 B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1 B0
Reason code
Byte 3 Byte 2
Sub-index
1
≦ n ≦ 254
B31 B30 B29 B28 B27 B26 B25 B24 B23 B22 B21 B20 B19 B18 B17 B16
Device number Error code
Device number Error source
0x00…0x1F XN300 slice module node number on the
system bus generating the error
0xFF XN-312-GW-EC
Error code Error information
1 The I/O mapping file stored in the system bus slave FPGA could not
be read
2 The I/O mapping file stored in the system bus slave FPGA could not
be parsed
3 The system bus slave could not be detected
4 A standard data object could not be created
5 The mailbox handler could not be started
6 Error while attempting to determine the cycle time
7 Error while attempting to set the cycle time
8 The input handler could not be started
9 Error while attempting to stop the input handler
10 The output handler could not be started
11 Error while attempting to stop the output handler
12 Error while attempting to create the PDO mapping
13 Attempt to copy the input PDOs failed
14 Attempt to copy the output PDOs failed
15 Error during SDO access to the system bus slave
16 PDO data reading could not be started