2018.12.12
© 2017 Eaton. All rights reserved
166
TRSM0940
Service Procedures
|
Main Case Main Shaft Disassembly with Low Force Gearing
5.
Remove the key from the Main Shaft keyway.
Note:
When removing no-burn washers or spacers,
note their location on the Main Shaft to facilitate reas-
sembly. Keep each washer with the corresponding gear
it was mated against.
6.
Remove the 1st stepped no-burn washer from the
Main Shaft.
Note:
There are two types of washers used on the Main
Shaft. The stepped washers (left) fit between gears and
sliding clutches with the stepped edge facing the slid-
ing clutch. The flat no-burn washers fit between gears.
Summary of Contents for UltraShift PLUS FM-14E310B-LAS
