2018.12.12
© 2017 Eaton. All rights reserved
158
TRSM0940
Service Procedures
|
Oil Pump and Lube Tube Installation
20.
Install the front upper Counter Shaft Bearing onto the
Counter Shaft and into the bore of the Transmission
Main Case.
Note:
Using an old race for the front Counter Shaft
Bearings helps keep the rollers in place during
installation.
21.
Install the front lower Counter Shaft Bearing retaining
washer and bolt and torque to 90–120 lb-ft.
22.
Install the upper Reverse Idler Shaft into the bore in the
intermediate wall. Pilot the shaft through the first
thrust washer and into the idler gear. Once the shaft
has cleared the bore of the gear, pilot the shaft through
the second thrust washer.
23.
Using a soft bar and soft maul, complete the installa-
tion of the Reverse Idler Shaft by placing the bar on the
end of the shaft and striking with the maul.
Summary of Contents for UltraShift PLUS FM-14E310B-LAS
