18
Installation
Requirements
Installation
Requirements
WetClutch Oil Fill Procedure
1.
Remove the dipstick and add a maximum of 18 pints (8.5 liters) of the specified oil through the fill tube (dip-
stick tube).
2.
Place the transmission in neutral position and apply the parking brakes. Start the engine and let it idle for five
(5) minutes, (this allows the oil to circulate and fill the cooling system).
3.
Add oil as needed to obtain the correct level.
4.
Increase the engine idle slowly to 1500 RPM for two (2) minutes.
5.
Check the oil level at normal idle speed in neutral, add or drain oil to make sure it is at the proper level on the
dipstick (between the cold ADD mark and cold FULL mark).
6.
Replace the dipstick and tighten securely.
Main Case Fill Procedure
Fuller® transmissions are designed so that the internal parts operate in a bath of lubricant circulated by the motion of
gears and shafts. Thus, all parts will be amply lubricated if these procedures are closely followed:
1.
Use Roadranger® CD 50 or equivalent synthetic per Eaton publication TCMT-0019.
2.
When adding lubricant, types and brands of lubricant should not be mixed because of possible incompatibility.
3.
Use clean lubricant and containers when filling the transmission. Containers that have been used for antifreeze
or water should not be used for transmission lubricant.
4.
Additives and friction modifiers are not recommended for use in Fuller transmissions.
Note:
Failure to adhere to Eaton Installation Requirements may effect Fuller UltraShift ASW performance and/or war-
ranty coverage.
Note:
The quantity for proper fill level will vary from unit to unit.
Wet
Vehicle Cooling system =
Total WetClutch Oil Capacity
(OEM responsibility)
Initial Fill 18 pints or (8.5 liters)
Varies depending upon application
Varies depending on oil cooler capacity
Transmission Gear Box Capacity
6-Speed 20.75 pints (9.8 liters)
