Eaton ProtoAir FPA-W34, Startup Manual

Page: 10 / 66

Eaton ProtoAir Start-Up Guide
Page 10 of 66
3 EQUIPMENT SETUP
3.1 Record Identification Data
Each ProtoAir has a unique part number located on the side or the back of the unit. This number should
be recorded, as it may be required for technical support. The numbers are as follows:
Model Part Number
ProtoAir FPA-W34-1130
Figure 1: ProtoAir Part Numbers

FPA-W34 units have the following 2 ports: RS-485 + Ethernet
3.2 Point Count Capacity and Registers per Device
The total number of registers presented by all the devices attached to the ProtoAir cannot exceed:
Part number Total Registers
FPA-W34-1130 10,000
Figure 2: Supported Point Count Capacity
Greengate Devices Point Count Per Device
3264640000 161
4864643204 213
808640000 81
344640003 115
1664643204 181
6464643200 225
Figure 3: Greengate Point Count per Device
iLumin Devices Point Count Per Device
Scene 2
Channel 2
Figure 4: iLumin Point Count per Device
NOTE: Fifth light points determined by panel configuration.
3.3 Configuring Device Communications

The device needs to be on the same IP subnet as the ProtoAir and the configuration PC.

Record the following device information for Greengate and iLumin setup:
o
IP Address
o
IP Port
o
Panel Address (Greengate only)
o
Number of Panels (Greengate only)
NOTE: This information is required for Section 6 .
NOTE: The iLumin application requires a iLumin configuration file to load device details.
NOTE: These parameters are not required for Fifth Light application.