63
Profile
Installation Manual
PROFILE INSTALLATION MANUAL
Eaton.com/profile
P a g e
|
61
Eaton’s Profile Command Console
Installation Manual
Step 10. Install The Electronic Control Boxes and Button Pads
A 2-channel control box is required for each motorized work surface. Mount each control box to the underside of the work
surface with (2) #10 x 1-3/4” long Phillips head screws, as shown in figure 99. The rear work surface control box mounts to the
right hand end of the work surface frame channel with its power receptacle pointing left towards the center of the desk. The
front control box mounts to the middle of the front work surface with its power receptacle pointing to the right.
Mount (1) button pad for each motorized work surface to the underside of the front work surface using (2) #8 x ¾” Phillips flat
head wood screws for each pad. If your linear sit-to-stand desk has only one motorized work surface, mount one control pad in
the right hand position. See figure 99.
#10 x 1-3/4” long
Phillips head wood
screws
#8 x ¾” Phillips flat
head wood screws
Button pad for rear
work surface
Power receptacle
this side
2-channel control boxes
(8-3/8” x 3-3/4”)
Button pad for
front work surface
Figure 98