58
Profile
Installation Manual
PROFILE INSTALLATION MANUAL
Eaton.com/profile
P a g e
|
56
Eaton’s Profile Command Console
Installation Manual
Step 3. Install The Lift Legs
a.
The following figures show the installation of a left hand A
1
style lift leg. B
2
style lift legs attach the same way.
b.
Refer to column 7 in table 84 to determine the lift leg inset. Then attach the lift leg assembly to the core wall with (5) ¼-20
x ½” hex head self-tapping screws, as shown in figure 88. (A 2-1/2” inset is shown in this example.)
c.
Install (2) #10 x 3/8” Phillips head self-tapping screws into the top of the lift leg face plate. Leave the screws protruding
about 1/16”. Engage the “U” slots in the top of the upper leg skin onto the screws. The lower leg skin magnetically
attaches to the face plate. See figure 89.
d.
Repeat these steps for the right hand lift leg assembly.
e.
Adjust the lift leg’s levelers to ensure that the leg assembly and core wall are plumb.
Upper leg skin
#10 x 3/8” Phillips
head self-tapping
screws (2)
Lift Leg Inset (See column 7 of table 84)
¼-20 x ½” hex head self-tapping screws (10)
Figure 88
Figure 89
Lower leg skin
Lift leg face plate